Oak Coil Box Wood
This coil box back plate and bottom wood is made of
Solid Oak and will give years of service. Some of the coil box replacement wood
parts on the market today are made from plywood. The adhesive can actually break down and
allow the high voltage from the coils a path to ground.
The photo below is a perfect example where the
plywood, adhesive and moisture, no doubt combined with the high voltage energy
and made a conductive path to ground.
On an International tour, one plug wouldn’t fire on
my 1915 Tow Truck, and after much troubleshooting, we found this problem. For an emergency repair, we bored the hole a
bit larger and wrapped the stud with electrical tape to get some extra
insulation.
The real solution was provided by Steve Tanck of
Front View Edge
View
Oak Coil
Box Wood: U$ 14.00 plus S&H (Note that this is the back plate and
bottom wood only, no hardware.)
S&H U$ 4.95 or add U$ 2.00 when ordered with
timer. Add U$ 2.00 for ex-USA Shipment
Frank’s Timer Service, 2251 Morgan Lane,
Ingleside, TX 78362
Telephone:
361-230-0318, e-mail: Frank@andersontimer.com