The new
Magneto Meter continuously monitors the Magneto Voltage of your Model
T Ford.
A magneto in good condition will
generate nearly 30 volts AC at high engine
speed.
Connect this meter to
the Magneto Terminal of your car and to ground.
It continuously monitors the magneto’s voltage, eliminating any
guesswork when troubleshooting problems.
This meter fits into
a 2-inch diameter hole and can be mounted using the three holes in the front
flange to mount in front of or behind the panel. It will also fit into a standard 2-inch
diameter mounting plate for mounting the meter under the dash or in a
convenient location. Screws can be used
for mounting, but RTV sealant will secure the meter behind the mounting plate
for a neat, clean installation. Note that this gauge
will not fit directly in the 2 ¼ inch early ammeter’s space without a bit of
adaptation.
Meter mounted under the steel dash Meter mounted on wood dash
Meter mounted on side brace wood.
Meter mounted to the
back of standard Early cars with
switch on coil box Later cars have
the magneto terminal
2 in. gauge bracket
with RTV Silicone. have the mag
terminal on coil box on the
terminal block.
Bracket sold
separately. Connect the other wire to a good
ground in either case.
The Magneto Meter, by
Steve Stephenson and Frank’s Timer Service $30.00 plus $5.00 to USA (inquire
ex-USA) shipped by USPS. Includes Meter,
hookup wire and crimp terminals. Add
$5.00 for Standard single gauge bracket similar to those pictured above.
Order from Frank’s
Timer Service,
Phone: 361-230-0318 e-mail: Frank@andersontimer.com Website:
www.andersontimer.com
Be sure to watch the
road too, not just the meter……… Always
work and drive safely…………