APCO Style

Radius Rod Anti-Rattler

Spring Loaded Radius Rod (Wishbone) Ball Support

The Model T Wishbone is fastened to the engine pan with a simple casting, which can wear over time, create clearance and can allow the wishbone to move and even rattle. The wishbone is the important component that holds the front axle secure, and looseness may cause shimmy or other steering troubles.

The APCO Style Spring Loaded Wishbone Ball Support ends this problem by applying a continuous spring tension on the ball through a special brass ‘button’ between the spring and the ball. The ‘button’ is made of brass and is concave to fit the radius of the wishbone ball. The special spring provides tension when compressed by the steel spring tensioning screw threaded into the tough cast brass body. The plug is secured by a cotter pin. Just add plenty of your favorite grease at installation.

Note the mounting of the APCO Style support uses the standard studs, springs and nuts which must be tightened securely until the springs are collapsed and secured with wire so that the studs cannot back out. The support’s spring tensioning screw must be secured with a cotter pin (included)

This unit is installed on a 1912 Delivery and has been run several thousand

miles including many tours.

Made In USA by: Ask your parts distributor or order directly from:

Frank’s Timer Service 361-230-0318 Price: US $ 50.00

2251 Morgan Lane Frank@andersontimer.com plus S&H $ 5.00

Ingleside, TX 78362 www.andersontimer.com (shipment by USPS)

User assumes all risks. Please work & drive safely.